Blade setup for 30 size

[ShowDown]

Having a problem getting my blades set up for my Raptor 30, any advise would be greatly appreciated.

[CSpaced]

What exactly is the problem?

[toro]

zero pitch @ center stick + 10 positive, + 10 negative. Adjust curves in normal Idle up 1 and 2. Normal curve if your just learning only give it a few degrees neg or none at all depending on your noobiness.

Tracking:..... Grab a sharpie, and color one blade a different color on the tip with about a 1 1/2" band. Find the low blade, and adjust up to the other blade. Some times if its way off you may need to adjust down to, but thats only if your hovering either way high on the stick, or way low. On the raptor dont adjust the small links from the grip to the mixinglevers, adjust the longer links connecting to the mixing levers from the swash. Also make sure your spindle is lubed, and your dampers are fresh. Lube your spindle with di-electric silicone grease available from any auto parts store. blade tightness will also cause blades to go out of track. Lead/lag issues. If one is tighter than the other by a whole bunch it will not lead/lag properly.

What is the exact issue your having.