JTerrell
04-11-2010, 08:41 PM
Align Trex 600N Pro with the following:
Align 50SXH motor with Align high performance muffler
Header Tank
Futaba GY520 Gyro with Futaba BLS251 Brushless servo on tail
Futaba S9452 on flight controls and S3151 on throttle.
Spektrum AR7000 receiver
Align 2 in 1 regulator with Fromeco 2300mah 7.4v Lion battery.
Mavrikk G5 pro carbon 600mm blades
Align carbon tail blades
Additional frame stiffeners
Red fiberglass canopy
The heli was built and only hovered for setup, has less than 2 tanks of fuel through the entire heli and all items were purchased new when built. This is a like new very clean Trex600N.
Just Bind and Fly.
$850.00
Align 50SXH motor with Align high performance muffler
Header Tank
Futaba GY520 Gyro with Futaba BLS251 Brushless servo on tail
Futaba S9452 on flight controls and S3151 on throttle.
Spektrum AR7000 receiver
Align 2 in 1 regulator with Fromeco 2300mah 7.4v Lion battery.
Mavrikk G5 pro carbon 600mm blades
Align carbon tail blades
Additional frame stiffeners
Red fiberglass canopy
The heli was built and only hovered for setup, has less than 2 tanks of fuel through the entire heli and all items were purchased new when built. This is a like new very clean Trex600N.
Just Bind and Fly.
$850.00